User Manual

Command Descriptions
Examples
SWLOSS:SAVE "A
:\Data2.CSV"
specifies the file name and path to save
switching loss measurement data to the oscilloscope CompactFlash card.
SWLoss:SOURCES
Sets or queries the input sources for Switching Loss measurements.
Before taking measurements, you must use the CH<x>:YUNit command to set
the units of the voltage and current sources.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:SOURCES { CH1CH2 | CH3CH4 }
SWLoss:SOURCES?
Related Commands
Arguments
CH1CH2 specifies Channel 1 and Channel 2 as the input sources.
CH3CH4 specifies Channel 3 and Channel 4 as the input sources.
NOTE. The"CH3CH4"argumentisonlyvalidfor instruments with four channels.
Examples
SWLOSS:SOURCES? might return CH1CH2.
SWLoss:STOPAfter
Sets or queries the number of measurements used for Switching Loss
measurement.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:STOPAfter <NR1>
SWLoss:STOPAfter?
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-159