User Manual
Command Descriptions
Conditions
This command ap
plies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measur
ement
Syntax
SWLoss:LOG:TOTAL?
Returns
<NR3>
Examples
SWLOSS:LOG:TOTAL? might return 9.079604 5959E-2.
SWLoss:LOG:TURNOFF? (Query Only)
Returns the Turn-Off Loss for a switching loss measurement specified by the
SWLoss:LOG:INDEX command.
NOTE. The oscilloscope generates error 221 if the SWLoss:LOG:INDEX?
command returns a number greater than that reported by SWLoss:AVErage:N?
This indicates that insufficient measurements have been taken to generate a log
report.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:LOG:TURNOFF?
Related Commands
Returns
<NR3>
Examples
SWLOSS:LOG:TURNOFF? might return 1.3477193192E-2.
SWLoss:LOG:TURNON? (Query Only)
Returns the Turn-On Loss for a switching loss measurement specified by the
SWLoss:LOG:INDEX command.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-157