User Manual

Command Descriptions
Returns
<NR3>
Examples
SWLOSS:AV
ERAGE:TURNOFF?
might return 1.3790115628E-2.
SWLoss:AVErage:TURNON? (Query Only)
Returns the power loss of the device under test when the device is transitioning
between
its off and on state. The oscilloscope reports this measurement in the Avg
column of the S witching Loss display.
You mus
t enter the saturation voltage of the device under test using the
SWLoss:VSAT command.
NOTE. This command returns error 221 (settings conflict) if the Switching Loss
menu is not active.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Modu
le only.
Group
Power Measurement
Syntax
SWLoss:AVErage:TURNON?
Returns
<NR3>
Examples
SWLOSS:AVERAGE:TURNON? might return 1.698264356E-2.
SWLoss:ENABLe
Sets or queries the switching loss menu, on or off.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analy
sis
Module only.
Group
Power Measurement
Syntax
SWLoss:ENABLe { ON | OFF }
SWLoss:ENABLe?
2-154 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer