User Manual

Command Descriptions
You must enter t
he saturation voltage of the device under test using the
SWLoss:VSAT command.
NOTE. This command returns error 221 (settings conflict) if the Switching Loss
menu is not active.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Module onl
y.
Group
Power Measurement
Syntax
SWLoss:AVErage:CONDUCTION ?
Returns
<NR3>
Examples
SWLOSS:AVERAGE:CONDUCTION ? might return 6.0880498608E-2.
SWLoss:AVErage:N? (Query Only)
Returns the number of measurements used to calculate the AVG. (averaged)
measurement value for switching loss measurements.
NOTE. This command returns error 221 (settings conflict) if the Switching Loss
menu is not active.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:AVErage:N?
Returns
<NR1>
Examples
SWLOSS:AVERAGE:N? might return 185, indicating that the oscilloscope used
185 measurements to calculate the average.
2-152 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer