User Manual

Command Descriptions
Conditions
This command ap
plies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
S
WLoss?
Examples
SWLOSS? might return the following: SWLOSS:ACQUIRE CONTINUOUS;EN ABLE
ON;SOURCES CH1CH2;STOPAFTE R 10 ;TONSTART 90;TONEND
10;TOFFSTART 10;TOFFEND 10;VSAT 4.3 00000190735E0;U NI
TS WATTS
SWLoss:ACQuire
Sets or queries the type of acquisition used for Switching Loss measurements.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analys
is
Module only.
Group
Power Measurement
Syntax
SWLoss:ACQuire { STOPAfter | CONTINUOUS }
SWLoss:ACQuire?
Related Commands
Arguments
STOPAfter instructs the oscilloscope to perform measurements on N a cquisitions
andthenstop.
CONTINUOUS instructs the oscilloscope to continuously acquire waveforms and
display measurements.
Examples
SWLOSS:ACQUIRE might return SWLOSS:ACQUIRE CONTINUOUS, indicating that
the oscilloscope is continuously taking switching loss measurements.
SWLoss:AVErage:CONDUCTION? (Query Only)
Returns the power loss of the device under test when the device is conducting in
its on state. The oscilloscope reports this measurement in the Avg. c
olumn of the
Switching Loss display.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-151