User Manual

Command Descriptions
Related Commands
FACtory, *RCL,
RECAll:SETUp
Arguments
<NR1> is an integer value in the range from 1 to 5 (TDS200 Series) or from 1 to 10
(TDS1000, TD
S2000, TDS1000B, TDS2000B, TDS2000C, and TPS2000 Series)
and specifies a memory location. Any settings that have been stored previously at
this location are overwritten.
Examples
*SAV 2 saves the settings in memory location 2.
SAVe:IMAge (No Query Form)
Saves the screen image to a file on the CompactFlash card (TDS2ME M and
TPS2000 Series only), o r on the USB flash drive (TDS1000B, TDS2000B, and
TDS2000C Series only).
Conditions
This command applies to the TDS2MEM, TDS1000B, TDS2000B, TDS2000C,
and TPS2000 Series only.
Group
Save and Recall
Syntax
SAVe:IMAge <file path>
Arguments
<file p ath> is a quoted string that defines the path and name of the screen
image file to save. Use file name extensions that are appropriate for image format.
If you do not specify a path to a folder, the oscilloscope saves the screen image file
in the current working folder, using the current save image file format. The current
folder refers to the name of a folder as returned by the FILESystem:CWD query.
Use the SAVe:IMAge:FILEFormat command to set the screen image graphical
file format.
Examples
SAVE:IMAGE " A:\PROD-TST\VID -EVAL.BMP" saves the screen image to the
file VID-EVAL.BMP in the folder A:\PROD-TST on the CompactFlash card
(TDS2MEM and TPS2000 Series only), or on the USB flash drive (TDS1000B,
TDS2000B, and TDS2000C Series only).
SAVe :IMAge:FILEFormat (No Query Form)
Sets the screen image file format used by the SAVe:IMAGE command and by
the SAVE > Action > Save Image and SAVE > Action > Save All front-panel
operations.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-145