User Manual

Command Descriptions
Examples
POWER:BATTERY
1:GASGAUGE?
might return 60, specifying that battery 1 is
60% charged.
POWer:BATTERY<x>:STATUS? (Query Only)
Returns the status of battery x, where x is Battery 1 or Battery 2.
Group
Power and Battery-Relat ed
Syntax
POWer:BATTERY<x>:STATUS?
Returns
FULL indicates that the battery is fully charged.
DISCHARGED indicates that the battery has no charge remaining. The battery can
be discharged, but still report a small percent remaining.
UNCALIBRATED indicates that the oscilloscope cannot predict the battery charge
remaining.
NOTINSTALLED indicates that the battery is not installed in the oscilloscope.
NORMAL indicates that the battery status is not any of the states in this list.
Examples
POWER:BATTERY1:STATUS? might return FULL, which indicates that Battery 1 is
at maximum capacity.
POWer:BATTERIES:TIME? (Query Only)
Returns the charge remaining in both batteries. This value is not accurate when
either battery is uncalibrate
d.
Group
Power and Battery-Relat ed
Syntax
POWer:BATTERIES:TIME?
Returns
<NR1> specifies the operating time remaining for both batteries in minutes.
Examples
POWER:BATTERIES:TIME? might return 10, specifying that the battery or
batteries installed can provide about 10 minutes of power to the oscilloscope.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-135