User Manual

Command Descriptions
CURSORRms (TDS
2000C Series) is the true Root Mean Square (RMS) value of the
selected waveform data, between the start point and the end point.
DELay (TDS200
0C Series) is the delay from one waveform’s edge event to
another.
FALL (TDS20
0 Series with a TDS2MM measurement module, TDS1000,
TDS2000, TDS1000B, TDS2000B, TDS2000C, and TPS2000 Series only) is the
fall time between 90% and 10% of the first falling edge of the waveform. Falling
edge must be displayed to measure. The oscilloscope automatically calculates
the 10% and 90% measurement points.
FREQuency is the reciprocal of the period measured in Hertz.
MAXImum (TDS1000, TDS2000, TDS1000B, TDS2000B, TDS2000C, and
TPS2000 Series only) is the value of the largest point in the waveform.
MEAN is the arithmetic mean over the entire w aveform.
MINImum (TDS1000, TDS2000, TDS1000B, TDS2000B, TDS2000C, and
TPS2000 Series only) is the value of the s mallest point in the waveform.
NWIdth (TDS200 Series with a TDS2MM measurement module, TDS1000,
TDS2000, TDS1000B, TDS2000B, TDS2000C, and TPS2000 Series only) is the
negative pulse width between the first falling edge and the next rising edge a t the
waveform 50% level. Falling and rising edges must be displayed to measure. The
oscilloscope automatically calculates the 50% measurement point.
PDUty (TDS2000C Series) is the ratio of the pulse width to the signal period,
expressed as a percentage.
PERIod is the duration, in seconds, of the first complete cycle in the waveform.
PHAse (TDS2000C Ser ies) is the phase difference from the selected waveform
to the d esignated waveform.
PK2pk is the absolute difference between the maximum and minimum amplitude.
PWIdth (TDS200 Series with a TDS2MM measurement module, TDS1000,
TDS2000, TDS1000B, TDS2000B, TDS2000C, and TPS2000 Series only) is the
positive pulse width between the first rising edge and the next falling edge at the
waveform 50% level. Rising and falling edges m ust be displayed to measure. The
oscilloscope automatically calculates the 50% measurement point.
RISe ( TDS200 Series with a TDS2MM measurement module, TDS1000,
TDS2000, TDS1000B, TDS2000B, TDS2000C, and TPS2000 Series only) is the
rise time between 10% and 90% of the first rising edge of the waveform. Rising
edge must be displayed to measure. The oscilloscope automatically calculates
the 10% and 90% measurement points.
The following are for use with the TPS2000 Series with the TPS2PWR1 Power
Analysis Module:
2-122 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer