User Manual

Command Descriptions
LIMit:RESUlt
:PASS? (Query Only)
Returns the number of pass cases.
G
roup
Limit Test
Syntax
LIMit:RESUlt:PASS?
Related Commands
LIMit:RESUlt:FAIL?, LIMit:RESUlt:TOTAL?
Examples
LIMIT:RESULT:PASS?
might return: 25, indicating that 25 test cases were detected as passing.
LIMit:RESUlt:TOTAL? (Query Only)
Returns the number of total c ases tested.
Group
Limit Test
Syntax
LIMit:RESUlt:TOTAL?
Related Commands
LIMit:RESUlt:FAIL?, LIMit:RESUlt:PASS?
Examples
LIMIT:RESULT:TOTAL?
might return: 25, indicating that there were 25 test cases detected.
LIMit:SAVEIMAge
Sets or returns whether the oscilloscope should save the screen image to a file on
a limit test failure event. When enabled, this command copies image data from
all active waveforms that have limit test failures to a file on the oscilloscope
flash memory drive.
Group
Limit Test
Syntax
LIMit:SAVEIMAge{OFF|ON|0|1}
LIMit:SAVEIMAge?
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-105