User Manual

Command Descriptions
Conditions
This command ap
plies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
HARmonics:SELect <NR1>
HARmonics:SELect?
Related Commands
Arguments
<NR1> specifies the harmonic from 1 to 50.
Examples
HARMONICS:SELECT 1 instructs the oscilloscope to select the first harmonic.
HARMONICS:SELECT? might return 3, indicating that the third harmonic is
selected.
HARmonics:SETUp
Sets or queries the operating mode of harmonics measurements.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
HARmonics:SETUp { MANUAL | AUTOMATIC }
HARmonics:SETUp?
Arguments
MANUAL The oscilloscope does not adjust the setup when entering or exiting the
harmonics measurement mode.
AUTOMATIC The oscilloscope adjusts various settings to optimize the harmonics
display. The oscilloscope returns to your previous settings when you exit the
harmonics measurement mode.
Examples
HARMONICS:SETUP might return AUTOMATIC.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-91