User Manual

Command Descriptions
Examples
HARMONICS:RMS
?
might return 120.0, indicating that the RMS value is 120
volts RMS.
HARmonics:SAVe (No Query Form)
Sets the file name a nd p ath to save the selected waveform harmonic data to the
oscilloscope CompactFlash card in .CSV format.
The following data is included in the file:
Harmonics, 1 through 50
Magnitude
Percent o
f fundamental
Frequency
Phase angle
NOTE. You can view the contents of the saved file on your personal computer. You
cannot
recall saved harmonics files to the oscilloscope.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Modu
le only.
Group
Power Measurement
Syntax
HARmonics:SAVe <file path>
Arguments
<file p ath> specifies the full path to save harmonic measurement da ta.
Examples
HARMONICS:SAVE “A:\data1.CSV" specifies the file name and path to save
harmonic loss measurement data to the oscilloscope C ompactFlash card.
HARmonics:SELect
Select
s an individual harmonic. If the harmonics function is enabled but the
requested harmonic is not currently on the screen, the oscilloscope will put it
on the screen. If the harmonics function is not enabled, the oscilloscope will
remember the requested value but will not enable the harmonics function.
2-90 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer