User Guide

Command Descriptions
MATH:VERtica
l:SCAle
Sets or returns the math waveform display scale in units per division. It is not
possible to use this command to set the math scale to a fine scale not achie v able
from the fron
t panel. This command typically rounds down to an achievable value.
If the value input is below the minimum value, then the command will round up.
Conditions
This command applies to the TDS1000B, TDS2000B, TDS2000C, and TPS2000
Series only.
Group
Math
Syntax
MATH:VERtical:SCAle <NR3>
MATH:VERtical:SCAle?
Arguments
<NR3> specifies the math vertical scale in units per division.
Examples
MATH:VERTICAL:SCALE 5. 0E0 sets the math vertical scale to five math
waveform units per division.
MEASUrement? (Query Only)
Returns the current MEASUrement settings.
Group
Measurement
Syntax
MEASUrement?
Returns
Oscilloscope measurement settings.
Examples
MEASUREMENT? might return the following:
MEASUREMENT:MEAS1:TYPE PERIOD;UNITS "S";SOURCE CH1;
MEASUREMENT:MEAS2:TYPE FREQUENCY;UNITS "HZ";SOURCE
CH1; ME ASUREMENT:MEAS3: TYPE PK2PK;UNITS "V";S
OURCE
CH2; ME ASUREMENT:MEAS4: TYPE MEAN;UNITS "V";SOURCE CH2 ;
:MEASUREMENT:IMMED:TYPE CRMS;UNITS "V";SOURCE CH1
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-119