User Manual

The default osci
lloscope settings (Default Setup)
The default os
cilloscope settings (Default Setup)
The following table lists the oscilloscope settings that are applied when you push the Default Setup button.
NOTE. When you push the Default Setup button, the oscilloscope displays the channel 1 waveform and removes all other
waveforms.
Function Setting and value
Acquire
Mode: Sam ple
Record length: 2000 points
Cursors Off
Source:Ch1
Display Persist: Auto
Mode: YT
Backlight: 80%
Graticule: On
FFT
Source wfm: On
Vertical Units: dBv RMS
Window: Hanning
Horizontal
Scale (time per major horizontal division): 4.00 s/div
Delay: On
Trigger position: 0.00 s
Math waveform Source 1: Ch1
Source 2: Ch2
Operation: + (add)
Measurements
Source:Ch1
Selected measurements: None
Trigger Type: Edge
Source: Ch 1
Coupling: DC
Slope: Rising
Level:0.00V
Mode: Auto
USB Device Port Connect to Computer
Vertical (all channels) Coupling: DC
Invert: Off
Bandwidth: Full
Voltage probe attenuation: 10X
Baseline position: 0.00 V
Scale (volts per major vertical division): 1.00 V
112 TBS2000 Series User Manual