User Manual

Setting up the Wi
-Fi network
Turning DHCP on or off (Wi-Fi)
A Dynamic Host Configuration Protocol (DHCP) network automatically allocates network IP addresses and settings
to DHCP-enabled instruments like the TBS2000 Series oscilloscope. Use this procedure to turn the oscilloscope
DHCP-capability on or off.
Prerequisites:
A supported Wi-Fi dongle is connected to the oscilloscope and is turned on. (See page 85, Turning Wi-Fi on or off.)
The network to which you are connecting must be DHCP-enabled.
1. Push Utility front-panel button.
2. Push the C
onfig side-menu button.
3. Use the M
ultipurpose knob to select and click Wi-Fi Config.
4. Highlig
ht DHCP.
5. Push the
Multipurpose knob to select ON. The oscilloscope takes a few moments to request and load the IP address
form the DHCP server. The LAN Test menu items should now show OK, and the network connection icon (upper
right edge of screen) should be on (white).
6. Push the knob again to turn DHCP Off.
TBS2000 Series User Manual 89