User Manual

Setting up the Wi

-Fi network

Setting the IP address (nonDHCP network) in Wi-Fi

If your network does not have Dynamic Host Con ﬁguration Protocol (DHCP) to automatically assign an IP address to the

oscilloscope, you must m anually enter IP address and other network settings so that your oscilloscope can connect to a

network. Use this procedure to enter IP address and other network settings.

Prerequisites:

A supported Wi-Fi dongle is connected to the oscilloscope and Wi-Fi is turned on. (See page 85, Turning Wi-Fi on or off.)

Obtain the correct network settings from your system administrator (IP address, Subnet Mask, and Default Gateway).

1. Push Utility front-panel button.

2. Push the C

onﬁg side-menu button.

3. Use the M

ultipurpose knob to select and click Wi-Fi Conﬁg.

4. Select a

nd click IP Addresses Settings. The oscilloscope opens the IP Addresses Settings dialog box.

5. Use the M

ultipurpose knob and side-menu buttons to enter the required network settings.

6. Push th

e OK side-menu button to enter the settings in the oscilloscope.

7. Conﬁrm

that the IP address was loaded into the oscilloscope. (See page 86, Viewing Wi-Fi settings.)

88 TBS2000 Series User Manual