User Manual

Setting up the Wi
-Fi network
Viewing Wi-Fi settings
Use this procedure to show the oscilloscope Wi-Fi settings.
Prerequisite: A Wi-Fi dongle is connected to the oscilloscope and Wi-Fi is turned on. (See page 85, Turning Wi-Fi on or off.)
1. Push the Utility front-panel button.
2. Push the Co
nfig side-menu button.
3. Use the Mul
tipurpose knob to select and click Wi-Fi C onfig.
4. Select and
click Wi-Fi Settings. The oscilloscope shows the IP address information and the Wi-Fi SSID and connection
signal level information.
Viewing and selecting available Wi-Fi networks
Use this procedure to see the Wi-Fi networks the oscilloscope can detect, and select the W i-Fi network to use for
communication.
Prerequisite: A Wi-Fi dongle is connected to the oscilloscope and Wi-Fi is turned on. (See page 85, Turning Wi-Fi on or off.)
1. Push the Utility front-panel button.
2. Push the Config side-menu button.
3. Use the M ultipu rpo se knob to select and click Wi-Fi Config.
4. Select and click Available Networks. The oscilloscope shows the networks and signal strengths of all the detected
Wi-F
i networks.
5. Sel
ect and click the Wi-Fi network to use for communication. A check mark in the network menu means that is the
selected network for communication.
86 TBS2000 Series User Manual