User Manual

Setting up the LA
Nnetwork
Setting up the
LAN network
The TBS2000 can connect to a LAN network to provide remote access to the instrument. Handy for classroom work,
remotely controlling the oscilloscope, re mote monitoring and analysis of waveforms. Use the procedures in this section to
connect the oscilloscope to a network using a CAT5 Ethernet cable. A separate section covers configuring the oscilloscope
to connect to a Wi-Fi network. (See page 85, Setting up the Wi-Fi network.)
Viewing the IP address - Ethernet
Use this procedure to see the oscilloscope IP address and related network settings. You may need the IP address
information to make a connection to the osc illoscope from a PC running on the network.
1. Push Utility front-panel button.
2. Push the Config side-menu button.
3. Use the Multipurpose knob to select and click Ethernet Config.
4. Select and click LAN Settings. The oscilloscope shows the IP address and other network-related settings. If no IP
address information is shown, and you need to s et up the oscilloscope for network access, work with your network
administrator to determine how to get an IP address.
82 TBS2000 Series User Manual