User's Manual

3-28
Section 3 — Menu Descriptions
MISC — Enables selection of the Aux Tally Back function, or allows
the selected GPI input to be disabled.
AUX TALLYAllows an external device to control the aux
bus tally level (high or low). The AUX BUS soft knob selects
the appropriate aux bus.
LOG CHANNEL TALLY Allows the Tally to track the DPM’s
logical channel .
DISABLE GPI — Causes any signal applied to the selected GPI
input to be ignored.
KF EFFECT — Enables selection of the Keyframe GPI function.
The following functions may be triggered with GPI pulses:
RUN, REWIND, AUTO RUN, and REVERSE
AUTO TRANS
— Enables selection of the Auto Transition GPI
function. The following transitions may be triggered with GPI
pulses:
M/E 1, M/E 2, M/E 3 (3000-3), PGM PST, DSK 1 and DSK 2 TITLE
MIX
, and PGM PST PST BLK
CUT
— Enables selection of the Cut GPI function. The following
cuts may be triggered by the GPI:
M/E 1, M/E 2, M/E 3 (3000-3), DSK 1, DSK 2, and PGM PST
E-MEM
— Enables selection of the E-MEM GPI function. The
following E-MEM functions may be triggered by the GPI:
RECALL ME 1, RECALL ME 2, RECALL ME 3 (3000-3), RECALL
MSTR, AUTO RECALL, EFF DISSOLV
, and SEQUENCE. The
REGISTER
soft knob selects the register for E-MEM recalls.
FRAME STORE — Enables selection of the Frame Store GPI
function. Triggerable functions are as follows:
VIDEO GRAB, KEY GRAB, and MASK GRAB
PROGRAM GPI
— For each GPI, after the desired function has been
selected, pressing PROGRAM GPI enters the selection, which is
then indicated in the table in the menu display.