Datasheet

Digital volt meter (DVM)

Measurement types DC, AC

RMS

+DC, AC

RMS

Voltage resolution 4 digits

Voltage accuracy

DC: ±((1.5% * |reading - offset - position|) + (0.5% * |(offset - position)|) + (0.1 * Volts/div))

De-rated at 0.100%/°C of |reading - offset - position| above 30 °C

Signal ± 5 divisions from screen center

AC: ± 2% (40 Hz to 1 kHz) with no harmonic content outside 40 Hz to 1 kHz

AC, typical: ± 2% (20 Hz to 10 kHz)

For AC measurements, the input channel vertical settings must allow the V

input signal to cover between 4 and 10 divisions and

must be fully visible on the screen

Trigger frequency counter

Accuracy ±(1 count + time base accuracy * input frequency)

The signal must be at least 8 mV

or 2 div, whichever is greater.

Maximum input frequency 10 Hz to maximum bandwidth of the analog channel

The signal must be at least 8 mV

or 2 div, whichever is greater.

Resolution 8-digits

Processor system

Host processor ARM 1.5 GHz, 32-bit, dual core processor

Internal storage 64 GB eMMC

Input-Output ports

HDMI-Video-Port

HDMI video port A 29-pin HDMI connector

Supported resolution: 1920 x 1080 @ 60Hz (only). The monitor must be attached before powering on the instrument

Probe compensator signal, typical

Connection: Connectors are located on the lower right-hand side of the instrument

Amplitude: 0 to 2.5 V

Frequency: 1 kHz

Source impedance: 1 kΩ

External reference input The time-base system can phase lock to an external 10 MHz reference signal (±4 ppm).

USB interface (Host, Device ports) Front panel USB Host ports: Three USB 2.0 Hi-Speed ports

Rear panel USB Host ports: Two USB 2.0 Hi-Speed ports

Rear panel USB Device port: One USB 2.0 High Speed Device port providing USBTMC support

Ethernet interface 10/100/1000 Mb/s

4 Series MSO