Datasheet

ManualsBrandsTektronix ManualsTest & MeasurementEmbedded Serial Triggering and Analysis Option - Tektronix 4 Series Mixed Signal Oscilloscopes

Serial protocol triggering and analysis (optional)

During debugging, it can be invaluable to trace the flow of activity through a

system by observing the traffic on one or more serial buses. It could take

many minutes to manually decode a single serial packet, much less the

thousands of packets that may be present in a long acquisition.

And if you know the event of interest that you are attempting to capture

occurs when a particular command is sent across a serial bus, wouldn't it

be nice if you could trigger on that event? Unfortunately, it's not as easy as

simply specifying an edge or a pulse width trigger.

Triggering on a CAN serial bus. A bus waveform provides time-correlated decoded packet content including Start, Arbitration, Control, Data, CRC and ACK while the bus decode table

presents all packet content from the entire acquisition.

The 4 Series MSO offers a robust set of tools for working with the most

common serial buses found in embedded design including I

C, SPI, I3C,

RS-232/422/485/UART, SPMI, CAN, CAN FD, LIN, FlexRay, SENT, USB

LS/FS/HS, Ethernet 10/100, Audio (I

S/LJ/RJ/TDM), MIL-STD-1553, and

ARINC 429.

Serial protocol search enables you to search through a long acquisition of

serial packets and find the ones that contain the specific packet content you

specify. Each occurrence is highlighted by a search mark. Rapid navigation

between marks is as simple as pressing the Previous ( ← ) and Next ( → )

buttons on the front panel or in the Search badge that appears in the

Results Bar.

The tools described for serial buses also work on parallel buses. Support

for parallel buses is standard in the 4 Series MSO. Parallel buses can be

up to 48 bits wide and can include a combination of analog and digital

channels.

Serial protocol triggering lets you trigger on specific packet content

including start of packet, specific addresses, specific data content,

unique identifiers, and errors.

Bus waveforms provide a higher-level, combined view of the individual

signals (clock, data, chip enable, and so on) that make up your bus,

making it easy to identify where packets begin and end, and identifying

sub-packet components such as address, data, identifier, CRC, and so

on.

The bus waveform is time aligned with all other displayed signals,

making it easy to measure timing relationships across various parts of

the system under test.

Bus decode tables provide a tabular view of all decoded packets in an

acquisition much like you would see in a software listing. Packets are

time stamped and listed consecutively with columns for each

component (Address, Data, and so on).

4 Series MSO