User manual

Performance Tests
CSA 803A Service Manual
4Ć27
ăStep 11:ă!"!, .* '! 4 ) check ./' ,!-/'.- #%)-. .$! .'!
-+!%"%.%*)- "*, .$! -!..%)# '!0!'- %) %.! 
NOTE
Specifications are one percent of full scale at each volts/div setting.
Example: at 5 mV/div full scale for 10 div is 50 mV, which gives an
upper and lower spec tolerance of +0.5 mV and -0.5 mV.
TableĂ4Ć3:ăVoltage Source Settings
Sens.
Source V Lower Spec Upper Spec
 ( %0
 ( %0
 ( %0
 ( %0
 ( %0
 ( %0
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 ( %0
 ( %0
 ( %0
 ( %0
 ( %0
 ( %0
 (
3(
3(
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
 (
NOTE
Up to now, you have been working with trace 1 (Channel 2) and
internal mainframe acquisition measurement channel 1. Use the
following steps to verify the vertical accuracy through internal
acquisition measurement channel 2, using trace 2. (Don't remove
Voltage Source from Calibration Head Channel 2).
ăStep 12:ă)%.%'%2! .$! (%)",(! - "*''*1-
 /..*) +,!--
Initialize %) (&*, (!)/ .*/$
Initialize %) 0!,%"%.%*) +*+4/+ (!)/ .*/$
ăStep 13:ă,%##!, .$!   - "*''*1-
 /..*) +,!--
Source %) (&*, (!)/ .*/$
Internal Clock %) +*+4/+ (!)/ .*/$