User manual

 

6Ć76
"   " #"(  ! "  ' " & "  " 
!#   "  "  #"   !"  (#" " ! $
 !#       #  (
NOTE
Match the index triangles on the multiĆpin connectors with the
corresponding square pads on the circuit board.
Some multiĆpin connectors are keyed by a gap between the pin 1
and 3 positions in the holder. (A small plastic plug covers the pin 2
position on the end of the holder.) There is a corresponding gap
between pins 1 and 3 on the circuit board.
Align the plug in the multiĆpin holder with the gap between the
circuit board pins. The connector is then ready to be installed.
'  "    #"(  " ! $   #  "
" !"     !  " "" %  ! ! 
"! " "  !     ! " "  "  (
! "  &    " " 
  "  '(   ! ' $ " #  "
" ! !"  "
  " ! $ " % "% #"!
H "  $  !"    " %  "!  %   !
%   #   "% " %  "!  " "  "
"  "  ! " " "% " % !  " "  " (
"  ! $! !"  " !"  % %# " %!  " 
" %  "!
H "  $  #(" " ! !"  #(" ! ""
! " "   " " ! # $  !!#  ! 
 !! " "   " " ! "!   "! 
!'
NOTE
To remove these ribbon connectors, grasp the pullĆtab (fastened
into the connector, if there) and pull it loose from the holder.
If there isn't a pullĆtab present in the connector, grasp the ends of
the connector, instead, and pull it straight out from the connector
socket.