User's Manual

Performance Tests
AWG2005 Service Manual
4Ć21
OscilloscopeAWG2005
AWG2005
Figure 4Ć8:ăAutostep Mode Initial Test Hookup
b.    
Vertical CH1
CH1 coupling DC
CH1 scale 0.5ĂV/div.
CH1 input impedance 50ĂΩ
Horizontal
Sweep 50õs/div.
Trigger
Source CH2
Coupling DC
Slope Positive
Level 100ĂmV
Mode Auto
2.        !  
a. #   Push UTILITYMiscConfig...ReĆ
set to FactoryO.K.
b. "   
 Push MODEAutostepSlope to highlight Positive.
 Push Run from the side menu to highlight Continuous.
 Select Level from the side menu, and turn the general purpose
knob to select 1ĂV.
 Select Select Autostep File from the side menu.
 Turn the general purpose knob to highlight the MODE_AST.AST
file.
 Push ENTER to select the file.
3.    Push the AWG2005 MANUAL TRIGGER button
and check that the oscilloscope momentarily displays a sine wave with a
different frequency and amplitude each time you push the button.
4.   Disconnect the oscilloscope.