User's Manual
'$'"# ()(
'$'"# ')$#
4Ć20
Push +$'" &*#, if necessary, to select a
waveform file for CH1. Waveform Sequence toggles between the
CH1 files (upper list) and the CH2 files (lower list).
Highlight the file using the general purpose
knob.
Push to select the file.
3. Push the button so that the LED
above the CH1 output connector is on.
4. "! ! Repeatedly push the AWG2005
button, and check that the oscilloscope displays a continuous
sine wave that switches between two frequencies at each manual trigĆ
ger.
5. Disconnect the oscilloscope.
*)$()% $
!)'! ')'() Operating mode, Autostep, on
pageĂ1Ć5.
&*%"#) &*' Two 50ĂΩ coaxial cables and an oscilloscope.
''&*()( The AWG2005 meets the prerequisites listed on page 4Ć7.
'$*'
1.
a.
Connect the AWG2005 CH1 output through a coaxial cable to
the oscilloscope CH1 vertical input.
Connect the AWG2005 rearĆpanel CH1 MARKER OUT output
through a coaxial cable to the oscilloscope CH2 vertical input
(see Figure 4Ć8). The CH1 MARKER OUT signal will serve as an
external trigger signal for the oscilloscope.