User's Manual

 !"!  !
! !
2Ć14
The following steps go through the process of selecting a file and modifying
individual output parameters.
1. Push the  button in the MENU column. The SETUP menu in
Figure 2Ć5 appears.
" %$ "
2. Select # " from the bottom menu. Waveform SeĆ
quence toggles between the CH1 files (upper list) and the CH2 files
(lower list).
3. Turn the general purpose knob to highlight a file in the displayed list of
files; these are the files currently in internal memory. Then, push 
to select the file; the AWG2005 changes to the output parameters
associated with the file you selected.
4. After the file is selected, push the front panel  button. Now you
can modify output waveform parameters.
5. Setting individual parameters:
Push the  button in the MENU column (if the button is not seĆ
lected). Now select the appropriate item from the bottom menu; then
use the numeric keys or general purpose knob to modify the parameter
setting.