User's Manual

   

6Ć42
    
1.  !    !   "
a. You will need a screwdriver with a size TĆ15 Torx tip to do this proceĆ
dure.
b. Locate the modules to be removed in the locator diagram,  
!, in Figure 6Ć4.
2. "  "    ! !  Do the  "
   ! ! s procedure on page 6Ć22.
3.   !  Set the AWG2005 with the bottom down on the work
surface and the left side facing you.
4. "   !
NOTE
       ! #    "$
    !
a. Disconnect the ribbon interconnect cable at J901 on the monitor
module. See Figure 6Ć19.
b. Remove the five screws securing the monitor module top and botĆ
tom to the chassis.
c. Release the snap at the right of the frontĆpanel module and shift the
assembly. Insert the screwdriver with a size TĆ15 Torx tip into the
right hole of the chassis, and then remove the screw securing the
monitor module.
d. Lift the monitor module up and away from the chassis to complete
the removal.