User's Manual

   

6Ć38
  
1.         You will need a
screwdriver with a size TĆ15 Torx tip to do this procedure. Locate the
modules to be removed in the locator diagram,  ,in
Figure 6Ć4.
2.   Set the AWG2005 with the bottom down on the work
surface and the left side facing you.
3.    
a. Disconnect the ribbon interconnect cable at J1, J3, J4, and J5 on
the power supply module. See Figure 6Ć17.
b. Disconnect the flat cable at J2 on the power supply module.
c. Using a screwdriver with a size TĆ15 Torx tip, remove the two screws
attaching the power supply module to chassis.