User's Manual

Removal and Installation Procedures
AWG2005 Service Manual
6Ć17
FrontĆpanel Knob
1.         You will need a
1
@
16Ć
inch hex wrench to do this procedure. Find the frontĆpanel knob on
the front panel in the locator diagram,  , Figure 6Ć3.
2.   Set the AWG2005 with the bottom down on the work
surface and the front facing you (see Figure 6Ć5).
3.    If the optional front cover is installed, grasp the front
cover by the left and right edges and snap it off of the trim ring. (When
reinstalling, align and snap back on.)
4.   Loosen the setscrew securing the knob using the
1
@
16
Ćinch
hex wrench. Pull the knob toward you to remove it.
5.  Place the knob onto the shaft, and tighten the setscrew
using the
1
@
16
Ćinch hex wrench.
Release
Hex Wrench,
1
@
16 inch
FrontĆpanel Knob
Figure 6Ć5:ăFrontĆpanel Knob Removal