User's Manual

Performance Tests
Performance Verification
4Ć48
a.    !
 Contact the oscilloscope probe to the pins on 2 X13 header (see
Figure 4Ć22). Check that the oscilloscope display shows these
signals:
 Data signals D0ĆD11 and CLK (Clock) are TTL level output.
 All other pins are ground.
Digital Data Out Cable


GND

GND
2X13 Header

Figure 4Ć22:ăOutput Pins on the Digital Data Out Cable
4.         
a.   Change the connection for the digital data out
cable from CH1 DIGITAL DATA OUT connector to CH2 DIGITAL
DATA OUT connector.
b. Repeat the step 2 and 3 to check the CH2 digital data output sigĆ
nals.
5.             
a.  "  #    Turn off power supply output.
b. !  Disconnect all connections to the AWG2005.