User's Manual
Performance Tests
AWG2005 Service Manual
4Ć45
Vertical CH1 and CH2
Coupling DC
Scale 0.2ĂV/div.
Input Impedance 50ĂΩ
Horizontal
Sweep 500õs/div.
Trigger
Source CH1
Coupling DC
Slope Positive
Level 0ĂmV
Mode Auto
Output Off
2.
a. Push UTILITYMiscConĆ
fig...Reset to FactoryO.K.
b. Load the CNTRL_IN.WFM file only to the master
AWG2005 using the performance check disk. For details on how to
load a file, see the Instruction for Operation in the section 2.
c.
Push SETUPWaveform Sequence, if necessary, to select a
waveform file for CH1. Waveform Sequence toggles between the
CH1 files (upper list) and the CH2 files (lower list).
Turn the general purpose knob to display the list of waveform
files and highlight the SLAVE.WFM file.
Push ENTER to select the file.
Push MODETriggered.
Press the bottom Configure button to select Master.
3.
a. Push UTILITYMiscConĆ
fig...Reset to FactoryO.K.
b.
Push SETUPWaveform Sequence, if necessary, to select a
waveform file for CH1. Waveform Sequence toggles between the
CH1 files (upper list) and the CH2 files (lower list).
Turn the general purpose knob to highlight the SLAVE.WFM file.
Push ENTER to select the file.
Push MODECont.