User's Manual

  !
 !
4Ć32
 Push the AWG2005   button, and check that
the displayed step is Step 3.
 Note the DMM reading as "C" for this value.
 Push the AWG2005   button, and check that
the displayed step is Step 4.
 Record the DMM reading as "D" for this value.
 Do the following calculation.
C-D
 Check that the calculated value is in the range from 9.850 V to
10.15 V.
4. Move the connection for the coaxial cable from the AWG2005 CH1
output to AWG2005 CH2 output connector.
5. Repeat procedure 3.
6.            Repeat
above procedure for CH3 and CH4 outputs.
7.   Retain the test hookup and control settings.
This procedure checks the accuracy of the AWG2005 offset.
! ! !  Main Output, Offset, Accuracy, on
pageĂ1Ć12.
"! " A 50ĂΩ coaxial cable, a 50ĂΩ termination, BNCĆtoĆ
dual banana adapter, and a digital multimeter (DMM).
" !  The AWG2005 meets the prerequisites listed on page 4Ć7.
"
1.      
a.    Connect the AWG2005 CH1 output through a 50ĂΩ
coaxial cable, a 50 Ω termination, and a dual banana connector to
the DMM INPUT connector (see Figure 4Ć14).
 ! "#
