User's Manual
)&)$% *+*
)&)$% )!!+!&%
4Ć30
b. Set oscilloscope controls:
Vertical CH1
Coupling DC
Scale 500ĂmV/div.
Input impedance 50ĂΩ
Horizontal
Sweep 500Ăns/div.
Trigger
Source CH1
Coupling DC
Slope Positive
Level 500ĂmV
Mode Auto
2. Set the AWG2005 controls and select the waveform file:
a. Initialize AWG2005 controls: Push !*&%!/
*+ +& +&).
b. Select the waveform file:
Push -&)$ (,%, if necessary, to select a
waveform file for CH1. Waveform Sequence toggles between the
CH1 files (upper list) and the CH2 files (lower list).
Turn the general purpose knob to select the
file.
Push to select the file.
3. Turn on the AWG2005 CH1 output: Push the button so that the LED
above the CH1 output connector is on.
4. Check clock amplitude accuracy: Check that the pulse amplitude of the
displayed waveform is 2 V
pĆp
or greater.
5. End procedure: Disconnect the oscilloscope.
This procedure checks the accuracy of the AWG2005 gain.
#+)!# )+)!*+! " Main Output, Amplitude, DC AccuĆ
racy, on pageĂ1Ć12.
(,!'$%+ (,!) A 50ĂΩ coaxial cable, a 50 Ω termination, a BNCĆtoĆ
dual banana adapter, and a digital multimeter (DMM).
))(,!*!+* The AWG2005 meets the prerequisites listed on page 4Ć7.
!% ,). "