Datasheet

SignalVu-PC application SV26 enables quick, standards-based transmitter
health checks on APCO P25 signals. The following image shows a Phase II
signal being monitored for anomalies with the spectrum analyzer while
performing transmitter power, modulation and frequency measurements.
Sophisticated WLAN measurements are easy. On the following 802.11g
signal display below, the spectrogram shows the initial pilot sequence
followed by the main signal burst. The modulation is automatically detected
as 64 QAM for the packet and displayed as a constellation. The data
summary indicates an EVM of -33.24 dB RMS, and burst power is
measured at 10.35 dBm. SignalVu-PC applications are available for
802.11a/b/j/g/p, 802.11n and 802.11ac to 40 MHz bandwidth.
With application SV27 you can perform Bluetooth SIG standard-based
transmitter RF measurements in the time, frequency, and modulation
domains. This application supports Basic Rate and Low Energy Transmitter
measurements defined by Bluetooth SIG Test Specification RF.TS.4.1.1 for
Basic Rate and RF-PHY.TS.4.1.1 for Bluetooth Low Energy. Application
SV27 also automatically detects Enhanced Data Rate packets,
demodulates them and provides symbol information. Data packet fields are
color encoded in the Symbol table for clear identification.
Pass/Fail results are provided with customizable limits and the Bluetooth
presets make the different test set-ups push-button. The measurement
below shows deviation vs. time, frequency offset and drift, and a
measurement summary with pass/fail results.
The SignalVu-PC MAP application enables interference hunting and
location analysis. Locate interference with an azimuth function that lets you
draw a line or an arrow on a mapped measurement to indicate the direction
your antenna was pointing when you take a measurement. You can also
create and display measurement labels.
Application SV28 enables the following LTE base station transmitter
measurements:
Cell ID
Channel Power
Occupied Bandwidth
Adjacent Channel Leakage Ratio (ACLR)
Spectrum Emission Mask (SEM)
Transmitter Off Power for TDD
There are four presets to accelerate pre-compliance testing and determine
the Cell ID. These presets are defined as Cell ID, ACLR, SEM, Channel
Power and TDD Toff Power. The measurements follow the definition in
3GPP TS Version 12.5 and support all base station categories, including
picocells and femtocells. Pass/Fail information is reported and all channel
bandwidths are supported.
RSA306B USB Spectrum Analyzer
4 www.tek.com
Preliminary Datasheet