User Manual

Kit Description
The RMU2U rackmount kit is a collection of parts that let you install one or two
supported instruments into a standard 19-inch equipment rack. You can install any
combination of two supported instruments.
CAUTION. This rackmount is intended for use in fixed installations only. It is not
intended fo
r mobile applications, or any other application where the rack mount
and mounted instruments are subject to vibration or shock.
Supported Products
This rackmount kit supports the following Tektronix bench instruments:
FCA3000, FCA3003, FCA3020, FCA3100, FCA3103, FCA3120,
MCA3027, MCA3040
PWS2185, PWS2323, PWS2326, PWS2721
PWS4204, PWS4305, PWS4323, PWS4602, PWS4721
DMM4020, DMM4040, DMM4050
AFG2021
Warranted Characteristics
When the instruments are installed according to the instructions in this document,
the rackmounted instruments meet all w arranted requirements listed in the
instrument specification. Instruments mounted using methods other than those
described in these instructions may not meet their warranted requirements.
See the Specifications section in the relevant document of your instrument for
information about the warranted characteristics.
C
learance Requirements
The rack in which the rack adapted instrument is mounted must provide 51 mm
(2 in) of clearance on at least one side of the instrument, and 51 mm (2 in) at the
rear of the instrument. For example, if two instruments are installed in the rack,
the outer sides must h ave 51 mm (2 in) of clearance.
CAUTION. Adhering to these requirements mounts the rack-adapted instrument
with enough clearance for air circulation and accommodation of the power
cord and mounting hardware. Failure to provide these clearances can result in
overheating and can cause the instrument to operate improperly or fail.
RMU2U Rackmount Kit 3