xx ZZZ FCA3000 and FCA3100 Series, MCA3000 Series, DMM4000 Series, PWS2000 and PWS4000 Series, AFG2021 Rackmount Kit RMU2U Instructions Warning The servicing instructions are for use by qualified personnel only. To avoid personal injury, do not perform any servicing unless you are qualified to do so. Refer to all safety summaries before performing service. www.tektronix.
Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or suppliers, and are protected by national copyright laws and international treaty provisions. Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published material. Specifications and price change privileges reserved. TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.
Service safety summary Only qualified personnel should perform service procedures. Read this Service safety summary and the General safety summary before performing any service procedures. Do not service alone. Do not perform internal service or adjustments of this product unless another person capable of rendering first aid and resuscitation is present. Disconnect power. To avoid electric shock, switch off the instrument power, then disconnect the power cord from the mains power.
Service safety summary 2 RMU2U Rackmount Kit
Kit Description The RMU2U rackmount kit is a collection of parts that let you install one or two supported instruments into a standard 19-inch equipment rack. You can install any combination of two supported instruments. CAUTION. This rackmount is intended for use in fixed installations only. It is not intended for mobile applications, or any other application where the rack mount and mounted instruments are subject to vibration or shock.
Kit Description Minimum Tool and Equipment List Required tools and equipment Part number Screwdriver, Phillips, #2 Standard tool 11/32 inch nut driver Standard tool Kit Parts List Figure 1: Rackmount kit parts diagram 4 RMU2U Rackmount Kit
Kit Description Table 1: Rackmount kit parts list Item Part number Optional Part for PWS2000, PWS4000 Series Instruments Quantity Description 1 407-5551-01 1 Tray, Rackmount 2 407-5552-00 2 Bracket, Lock 3 407-5553-00 2 Bracket, Extended 4 212-0251-00 14 Screw, Machine 10-32 X .500l, Truss Head, Phil 5 210-0458-00 4 Hex Nut, 8-32 X .344, With Lock Washer 6 211-1351-00 4 Screw, Machine 6-32 X .
Installation Installation NOTE. These instructions will work for most installations. However, the available space and access to the rack rear and sides may require you to modify the order of these installation instructions to install the instrument tray in your particular rack configuration. 1. Remove the handle from the instrument if present. Store the item in a labeled plastic bag. 2. Remove all boots and feet from the instrument. Store these items in a labeled plastic bag.
Installation 3. Install the side brackets () over the posts on the side of the rackmount tray () using the hex nuts with lock washers (). Lightly tighten the nuts so that the side brackets can slide enough to allow for adjustment when installing the assembly in the rack. 4. Remove the front side screws or plugs from the appropriate side of the instrument.
Installation 7. Attach the rear of the instrument to the edge of the rackmount tray using one locking bracket () and screw (). Use the locking bracket hole in the rackmount tray that is best suited for the instrument. NOTE. The locking bracket sides have two different lengths. Install the locking bracket so that the instrument is not loose when the bracket is tightened. 8. If you are installing two instruments, repeat steps 6 and 7 for the second instrument. 9.
Installation 12. Tighten the side bracket hex nuts (). 13. Connect the power, signal, and/or control cables as appropriate for the instrument. You have completed the rackmount installation procedure.