Manual

Advanced Features and Troubleshooting Manual 85

Troubleshooting Phaser 750 Printers

Enabling and disabling SysStart Job execution

You may load a startup (Sys/Start) file onto an optional internal IDE hard disk. The

Sys/Start job file is similar to an init file: When you turn on the printer, the file

executes — providing that Sys/Start has been enabled through a control file downloaded

to the printer.

You can also control SysStart Job execution from the printer’s front panel Printer Defaults

menu, using the Startup Mode option.

1. Press Menu; and scroll to Configuration.

2. Press Menu; and scroll to Startup Mode. Scroll to On and press OK; the printer

displays the following:

3. Press until Ready appears.

Macintosh users

1. From the printer’s CD-ROM, run the Installer application. Select Custom Install.

Select Printer Utilities. From your computer’s hard disk, open the PhaserTools folder.

2. From the PhaserTools folder, double-click Apple Printer Utility.

■ Under AppleTalk Zones, select your printer’s zone.

■ Under Printers, select your printer.

■ Click Open Printer.

3. From the Utilities menu, select Send PostScript File.

4. From the PhaserTools folder, open the Printer Utilities folder; select SysStartJob; click

Add.

5. Click Send.

Conﬁguration

<---- ----> Menu

Startup Mode

<---- ----> : On