User Manual

The menu system
You can specify
any channel or group parameter listed below in addition to the
voltage input on each of the four analog inputs.
Valid characters are A-Z,0-9,.,x,-,+,/,(,),:,space ,
and ^
No more than 100 characters can be used
The number format is [+/-]<decimal digits>[E[+/-]exponent]
When entering a formula you can use the left and right arrow keys to move the
cursor. This allows for easy correction and changing of complex formulas.
Each math function can be either enabled or disabled. Only enabled
results are
available for display.
The valid channel parameters are CH<1 – 4> followed by ":" and then one of the
following parameters:
Table 6: Valid channel parameters
VRMS – Volts RMS ACF – Amps Crest Factor
VAHF – Fundamental VA Hours
ARMS – Amps RMS
VTHD – Voltage Total Harmonic Distortion VARHF – Fundamental VAR Hours
W – Watts VDF – Voltage Distortion Factor VF – Fundamental Volts
VA – Volt-Amps
VTIF – Voltage Telephone Influence
Factor
AF – Fundamental Amps
VAR – Volt-Amps Reactive ATHD – Amps Total Harmonic D istortion WF – Fundamental Watts
FREQ – Frequency
ADF – Amps Distortion Factor VAF – Fundamental Apparent Power
PF – Power Factor
ATIF – Amps Telephone Influence Factor
VARF – Fundamental Volt-Amps Reactive
VPKP – Volts Peak (positive)
Z – Impedance PFF – Fundamental Power Factor
VPKN – Volts Peak (negative)
R – Resistance
VRNG – Voltage Range
APKP – Amps Peak (positive)
X – Reactance
ARNG – Amps Range
APKN – Amps Peak (negative) TINT– Integration Time (Hours)
VLL – Line-to-Line Voltage
VDC – Volts DC
WHR – Watt Hours VLN – Line-to-Neutral Voltage
ADC – Amps DC
VAHR – VA Hours VHA<1–99> – Voltage Harmonic Angle
(1-99)
VRMN – Rectified Mean Volts
VARH VHM<1-99> – Voltage Harmonic
Magnitude (1-99)
ARMN – Rectified Mean Amps
AHR – Amp Hours
AHA<1-99> – Current Harmonic Angle
(1-99)
VCMN – Volts Corrected Rectified Mean
WAV – Average Watts
AHM<1-99> – Current Harmonic
Magnitude (1-99)
ACMN – Amps Corrected Rectified Mean
PFAV – PF Average WHM<1-99> – Watts Harmonic
Magnitude (1-99)
VCF – Volts Crest Factor CORRVARS – Correction VArs
The valid group parameters are GRP<A-D>: followed by one of the following
parameters:
PA3000 Power Analyzer User Manual 57