User Manual

The menu system
The required me
asurements are selected in the Measurements menu. (See page 36,
Measurements.) The integrator measurements are:
Hours
Watt-Hours
VA-Hours
VA r - H o u r s
Amp-Hours
Average Watts
Average P
F
Correction VAr
Fundamental VA-Hours (VAHf)
Fundamental VAr-Hours (VArHf)
These measurements are on a per-group basis. The measurements can only be
selected and displayed when the group is in integrator mode. If an integrator
measurement is selected and the mode is changed to a non-integrator mode, then
the measurements will show as not being selected. Changing the group mode back
to int
egrator mode restores the selection previously used.
Configuring Integrator
mode
After selecting integrator mode, and the measurements to display, there are a
number of options provided for starting and stopping the integrator under Modes
→ Se
tup Mode → Integrator Setup. The following options are available:
Start Method. Select from Manual, Clock, or Level.
Configure Clock Start. Specify a Start Time and Start Date.
Duration. Specify the integrator run duration, measured in minutes. A
duration of 0.0 will run indefinitely.
Configure Level. Select a channel, signal, threshold, or direction.
CVArs Power Factor. Specify the desired power factor to be used for the
correction VArs in the range of ±1.0 V.
44 PA3000 Power Analyzer User Manual