User Manual

The menu system
Selection down or bottom o f list
Select measurement to be a result on the
screen or de-select measurement
To navigate to a desired result, use the up and down arrow soft keys. The current
selection will be highlighted in blue.
If a result is s elected, it has a green check mark at the right edge of the list.
The results screen shows all the selected results, in the order in which they appear
in the measurement list; the list only applies to the selected group.
NOTE. Unless the group is in Integrator mode, integration measurements cannot
be selecte d. These measurements a re:
Hours
Watt-Hours
VA-Hours
VAr-Ho
urs
Amp-Hours
Average Watts
Average PF
Correction VAr
Fundamental VA-Hours (VAHf)
Fund
amental VAr-Hours (VArHf)
To change the order of the results, navigate to the desired result and then press
. When the key is pressed, the highlight bar changes from blue to red.
Th
e soft keys will then change as shown below:
Go
back to the previous menu
Move selected measurement up (gray if at the
top of the list already).
Cancel the move, and put the measurement
back where it was before the move was started.
Move selected measurement down (gray if at
the bottom of the list already).
Place the measurement in the selected
position. The soft keys will change back to the
standard measurement screen keys.
PA3000 Power Analyzer User Manual 37