User Manual

Compliance information
Australia / New Z ealand
Declaration of
Conformity EMC
Complies with t
he EMC provision of the Radiocommunications Act per the
following standard, in accordance with ACMA:
CISPR 11. Radi
ated and Conducted Emissions, G roup 1, Class A, in
accordance with EN 61326-1.
Safety compliance
This section lists the safety standards with which the product complies a nd other
safety compliance information.
EU declaration of
conformity low voltage
Complian
ce was demonstrated to the following specication as listed in the
Ofcial Journal of the European Union:
Low Volta
ge Directive
EN 61010
-1. Safety Requirements for Ele ctrica l Equipment for Measurement,
Control, and Laboratory Use Part 1: General Require me nts .
EN 6101
0-2-030. Safety Requirements f or Electrical Equipment for
Measurement, Control, and Laboratory Use Part 2-030: Particular
requirements for testing and measuring circuits.
Equipment type
Test
and measuring equipment.
Safety class
Class1–groundedproduct.
Pollution degree
descriptions
A measure of the contaminants that could occur in the environment around
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
Pollution degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in t his category are generally encapsulated, hermetically sealed, or
l
ocated in clean rooms.
Pollution degree 2. Normally only dry, nonconductive pollution occurs.
O
ccasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical ofce/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
PA3000 Power Analyzer User Manual xiii