User Manual

Important safety information
Use only correc
t Measurement Category (CAT), voltage, temperature, altitude,
and amperage rated probes, test le ads, and adapters for any measurement.
WARNING. To prevent electrical shock, do not exceed the maximum measurement
or maximum floating v oltage for the test lead.
Connect and disconnect properly. Connect the test leads to the measurement
product before connecting it to the circuit under te st. Connect the ref erence test
lead to the circuit under test before connecting the test lead input. Disconnect
the test lead input and the reference test lead from the circuit under te st before
disconne
cting the test leads from the measurement product.
Connect and disconnect properly. De-energize the circuit under test before
connecting or d isconnecting the test leads.
Do not connect a test le ad to any circuit that carries voltages above the voltage
rating of the test lead.
Inspect the test leads and accessories. Before each use, inspect test leads and
accessories for damage (cuts, tears, or defects in the test lead body, accessories, or
cable jacket). Do not use if damaged.
Floating measurement use. Do not float the reference lead above the rated float
voltage.
Servicesafetysummary
The Service safety summary section contains additional information required to
safely perform service on the product. Only qualified personnel should perform
service procedures. Read this Service safety summary and the General safety
summary before performing any service procedures.
To avoid electric shock. Do not touch exposed connections.
Do not service alone. Do not perform internal service or a djustments of this
product unless another person capable of rendering first aid and resuscitation is
present.
Disconnect power. To avoid electric shock, switch off the product power and
disconnect the power cord from the mains power before removing any covers or
panels, or opening the case for servicing.
Use care when servicing with power on. Dangerous voltages or currents may exist
in this product. Disconnect power, remove battery (if applicable), and d isconnect
test leads before removing protective panels, soldering, or replacing components.
x PA3000 Power Analyzer User Manual