User Manual

Remote operation
Integrator mode (cont.)
Description
This command sets the direction of signal change when using level trigger
start.
Syntax
:MOD:INT:DUR <durat ion>
Where <duration> is the time in minutes
Description
This command sets the duration for integration, a value of 0.0 to 10,000.
Syntax
:MOD:INT:PF <power factor>
Where <power factor> is the desired power factor
Description
This command sets the desired power factor for correction VArs, a value
of +1.0 t
o –1.0.
Syntax
:MOD:INT:RUN
Description This command starts integration on all integrators.
Syntax
:MOD:INT:STOP
Description This command stops integration on all running integrators.
Syntax
:MOD:
INT:RESET
Desc
ription
This
command resets integration on all integrators.
:MO
D:PWM
NOTE
. There are no specific PWM Motor mode commands other than the normal
:MOD:PWM command to s elect PWM Motor mode.
82 PA3000 Power Analyzer User Manual