User Manual

Remote operation
Sum results (cont.)
Syntax
:SUM:AMP:METHD?
:SUM:VLT:METHD?
Returns
The summation method (1 or 2)
Mode setup commands
Themodes
etup commands correspond to the Modes menu. (See page 42, Modes.)
They are used to control how groups are configured to measure parameters in
certain conditions.
:MOD
Mode
Syntax :MOD:NOR (normal mode)
:MOD:BAL (ballast mode)
:MOD:SBY (standby power mode)
:MOD:INT (integrator mode)
:MOD:PWM (PWM Motor mode)
Description
This command will set the mode for the group. Because this command
works with a group, use the :INST:NSEL command first to select the active
group.
Syntax :MOD?
Returns
Mode number from 0 to 4
Description
This command will return a reference to mode for the active group.
Because this command works with a group, use the :INST:NSEL command
first to select the active group.
The returned values are:
0 – Normal Mode
1 – Ballast Mode
2 – Standby Power Mode
3 – Integrator Mode
4–PWMMotorMode
:MOD:BAL
Ballast mode
Syntax
:MOD:BAL:FREQ <value >
Where <value> is the power frequency in the range of 45 to 1000 Hz
Description
This command sets the power frequency for ballast mode. (See page 42,
B
allast mode .) B ecause this command works with a group, use the
:INST:NSEL command first to select the active group.
Syntax
:MOD:BAL:FREQ?
PA3000 Power Analyzer User Manual 79