User Manual

Performance Ver
ification
Required Equipment
Table 5 lists the equipment required to perform the performance verification procedure. The types and quantities o f
connectors may vary depending on the specific equipment you use.
NOTE. The procedures in this section require a network analyzer to perform the analog bandwidth and CMRR tests.
Alternative procedures that do not require a network analyzer are i ncluded in this manual.
Table 5: Test equipment
Description Minimum requirem ents Example product
Network analyzer
100 kHz to ≥2 GHz, with cables and
adapters to BNC male and SMA male
Hewlett Packard 8753D
Sampling oscilloscope Tektronix TDS8000 series
oscilloscope
Sampling Module
TDR output; 250 mV step, <100 ps rise
time
Tektronix 80E04
Power Supply
Tektronix 1103 power supply
BNC-to-probe tip adapter Optional probe accessory
Tektronix 067-1734-xx
BNC-to-SMA Female adapter (2)
As per description Tektronix 015-0572-xx
Calibrated DC voltage source (2) Adjustable from 0 V to ≥42 V. Outputs
must be isolated from earth ground.
Keithley 2400
DMM (2 required) DC Accuracy ≥ 0.5% on range to
measure 42 V, averaging mode.
Fluke 187
BNC cables (2) 50 Ω,42inch
Tektronix 012-0057-xx
SMA cable (2) 50 Ω,28inch
Tektronix 012-0649-xx
Banana-to-banana patch cords (3)
2red
1black
Tektronix 012-0031-xx
Tektronix 012-0039-xx
Dual-male-banana-to-female BNC
adapter (3)
As per description Tektronix 103-0090-xx
BNC male to dual binding post
adapter (2)
As per description Tektronix 103-0035-xx
Precision inline BNC terminator 50 Ω ±0.1%
Tektronix 011-0129-xx
Y-lead
Standard accessory included w/probe
Tektronix 196-3434-xx
MicroCKT test tip (2) Standard accessory included w/probe
Tektronix 206-0569-xx
0.025” square pins (3) Approximately 3/4 inch long, smooth,
gold plated.
Note: The equipment listed below is for the optional 42 V rise time test.
High Voltage P ulse Generator
42 V, 300 ps rise time
Picosecond Labs 2600C
Probe calibration fixture Optional probe accessory
Tektronix 067-0419-xx
Termination
50 W, 50 Ω, SMA connector
JFW 50T 334–1.0
16 P6250 & P6251 Technical Reference