User manual

Service Information
Table 3: Maximu
m ratings
Characteristic Information
Maximum continuous (CW) current
1mA/mV
10 mA/mV
Refer to figure for frequency derating curves
(See Figure 4.)
6A
p-p
sine wa
ve between 10 kHz and 10 MHz
6A
p-p
sine wave between 3 kHz and 10 MHz
Maximum pul
se current
100 A peak, not to exceed 9(A · ms) or
2A
RMS
. An (A · s) product greater than 9
(A · ms) redu
ces probe output to zero due
to core saturation
Maximum vo
ltage on bare w ire
1
Insulated wire only for voltages above
30 VAC, 42 Vpk, 60 VDC.
1
An insulated conductor is any conductor that is surrounded by an insulating material that is capable of isolating
the voltage present on the conductor. Lacquer coatings like those typically found on transformer windings do not
provide sufficient, reliable insulation for use with current probes. The lacquer coating can be easily nicked or
damaged, which compromises the insulating capabilities of the lacquer coating.
Figure 4: Probe and termination input current vs. frequency derating
10 P6022 Instruction Manual