User manual

Compliance Information
This section lists the safety and environmental standards with which the
instrument complie s.
Safety Compliance
EC Declaration of
Conformity – Low Voltage
Compliance was demonstrated to the following specifi cation as listed in the
Official Journal of the European Communities:
Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
EN 61010-2-032: 2002. Particular requirements for handheld current clamps
for electrical measurement and test equipment.
Additional Compliances
IEC 61010-1: 2001. Safety requirements for electrical equipment for
measurement, control, a nd laboratory use.
IEC 61010-2-032: 2002. Particular requirements for handheld current clamps
for electrical measurement and test equipment.
Equipment Type
Test and measuring equipment.
Safety Class
Class1–groundedproduct.
Pollution Degree
Description
A measure of the c ontaminants that could occur in the environment around
and within a p roduct. Typically the internal environment inside a product is
considered to be the same as the exte rnal. Products should be used only in the
environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulat ed, hermetic ally se aled, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
P6022 Instruction Manual vii