Instructions

Service Information
P6021 Instruction M anual
9
Table 4: Certifications and compliances
EC Declarat ion of Conformi ty — Low Voltage
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
Low Volt age Directi ve 73/23/ EEC, as amended by 93/68/EEC
EN 61010-1/A2
Part 1: General Requirements
Safety requirements for electrical equipment for
measurement, control, and laboratory test
EN 61010-2-032:1995 Part 2-032:
Particul ar requirements for hand-held current clamps
for electrical measurements and test
Listed UL1244, Third Edition Electrical and electronic measuring and test
equipment
Installation category descriptions
Termi nals on this product may have different installation category
designations. The inst allation cat egories are:
CAT III
Distribution-level mai ns (usually permanently
connected). Equipment at this level is typically in a
fixed indust rial l ocation
CAT II Local-level mains (wall sockets). Equipment at this
level includes appli ances, portable tools, and similar
products. Equipment is usually cord-connected
CAT I Secondary (signal level) or battery operated circuits
of electronic equipment
Pollution Degree 2 Do not operate in environments where conductive
pollutants may be present.
Typical Characteristics
This section lists the various typical characteristics that describe the P6021
Current Probe. Included are typical electrical and mechanical characteristics.
Typical characteristics are described in terms of typical or average performance.
Typical characteristics are not warranted.
Table 5: Electrical characteristics
Characteristic Information
Tilt
2 mA/mV 2.8% or less within 10 sofstep
10 mA/mV 7.5% or less within 100 sofstep