Datasheet

The MagniVu high-resolution record provides 121.2 ps timing resolution, enabling you to
take critical timing measurements on your digital waveforms.
P6316 MSO probe
This unique probe design offers two eight-channel pods, simplifying the
process of connecting to the device-under-test. When connecting to square
pins, the P6316 can connect directly to 8×2 square pin headers spaced on
tenth-inch centers. When more attachment flexibility is required, you can
use the included flying lead sets and grabbers to clip onto surface mount
devices or test points. The P6316 offers outstanding electrical
characteristics applying only 8 pF of capacitive loading with 101 kΩ input
impedance.
The P6316 MSO probe offers two eight-channel pods to simplify connecting to your
device.
Serial Protocol Triggering and Analysis
(optional)
On a serial bus, a single signal often includes address, control, data, and
clock information. This can make isolating events of interest difficult.
Automatic trigger, decode, and search on bus events and conditions gives
you a robust set of tools for debugging serial buses.
Triggering on a specific address and data packet going across an I
2
C bus. The yellow
waveform is clock and the blue waveform is the data. A bus waveform provides decoded
packet content including Start, Address, Read/Write, Data, and Stop.
Serial triggering
Trigger on packet content such as start of packet, specific addresses,
specific data content, unique identifiers, etc. on popular serial interfaces
such as I
2
C, SPI, RS-232/422/485/UART, USB2.0, CAN, LIN, FlexRay,
MIL-STD-1553, and I
2
S/LJ/RJ/TDM.
Bus display
Provides a higher-level, combined view of the individual signals (clock,
data, chip enable, etc.) that make up your bus, making it easy to identify
where packets begin and end and identifying sub-packet components such
as address, data, identifier, CRC, etc.
Bus decoding
Tired of having to visually inspect the waveform to count clocks, determine
if each bit is a 1 or a 0, combine bits into bytes, and determine the hex
value? Let the oscilloscope do it for you! Once you’ve set up a bus, the
MDO3000 Series will decode each packet on the bus, and display the value
in hex, binary, decimal (USB, LIN, FlexRay, and MIL-STD-1553 only),
signed decimal (I
2
S/LJ/RJ/TDM only), or ASCII (USB, MIL-STD-1553 and
RS-232/422/485/UART only) in the bus waveform.
Mixed Domain Osciloscopes -- MDO3000 Series
www.tektronix.com 11