Datasheet

Data Sheet
www.tektronix.com/dmm4050_40404
Characteristics
General Specifcations
Voltage
Characteristic Description
100 V Setting 90 V to 110 V
120 V Setting 108 V to 132 V
220 V Setting 198 V to 242 V
240 V Setting 216 V to 264 V
Frequency 47 Hz to 440 Hz. Automatically sensed at power-on
Power Consumption 28 VA peak (12 Watt average)
Dimensions
Dimension mm in.
Height 88 3.46
Width 217 8.56
Depth 297 5.8
Weight kg lb.
Net 3.6 8.0
Shipping 5.0 11.0
Display
Vacuum Fluorescent Display, dot matrix
Environnement
Characteristic Description
Temperature
Operating 0 °C to 55 °C
Storage -40 °C to 70 °C
Warm Up 1 hour to full uncertainty specifications
Relative Humidity (noncondensing)
Operating <90% (0 °C to 28 °C)
<80%(28 °C to 40 °C)
<50%(40 °C to 55 °C)
Storage <95% (-40 °C to 70 °C)
Altitude
Operating 2,000meters
Storage 12,000meters
Vibration Complies with Mil-T-28800F Type III, Class 5 (Sine only)
Safety Designed to comply with IEC 61010-1:2000-1, UL
61010-1A1, CAN/CSA-C22.2 No. 61010.1, CAT I 1000V
/ CAT II 600 V
EMC Designed to comply with IEC 61326-1:2000-11 (EMC)
when used with shielded communications cables. This
meter has shown susceptibility to radiated frequencies
greater than 1 V/m from 250 to 450 MHz
Triggering
Characteristic Description
Samples per Trigger 1 to 50,000
Trigger Delay 0 s to 3600 s; in 10 μs increments
External Trigger Delay <1 ms
External Trigger Jitter <500 μs
Trigger Input TTL Levels
Trigger Output 5 V max (open collector)
Memory
Model Description
DMM4050/4040 10,000 measurements, internal, and up to 2 Gigabyte
capacity with USB memory module (available separately)
through front-panel USB port
Math Functions
Zero, dBm, dB, MX+B, Offset, DCV ratio and TrendPlot, Histogram, Statistics
(min/max/average/standard deviation), and Limit Test
Electrical
Characteristic Description
Input Protection 1000 V all ranges
Overrange 20% on all ranges except 1000 VDC, 1000 VAC, Diode,
and 10 A ranges
Remote Interfaces
RS-232C, DTE 9-pin, 1200 to 230400 baud (RS-232C to USB cable available to
connect the meter to a PC USB port) IEEE 488.2.
LAN and “Ethernet 10/100Base-T with DHCP (for IP address) option”.
Warranty
Three years