User manual

Preparing the Meter for Operation
Installing the Meter into an Equipment Rack 2
2-9
Installing the Meter into an Equipment Rack
The Meter is mountable in a standard 19-inch rack using a rack mount kit. See the
“Accessories” section in Chapter 1 for ordering information.
To prepare the Meter for rack mounting, remove the bail and remove the front and rear
protective boots. To remove a boot, stretch a corner then slide it off as shown in Figure 2-
4.
To install the Meter into the rack, refer to the instructions provided with the Rack Mount
Kit.
eue22.eps
Figure 2-4. Boot Removal
Cleaning the Meter
XW Warning
To avoid electric shock or damage to the Meter, never get water
inside the Meter.
W Caution
To avoid damaging the Meter’s housing, do not apply solvents
to the Meter.
If the Meter requires cleaning, wipe it down with a cloth that is lightly dampened with
water or a mild detergent. Do not use aromatic hydrocarbons, alcohol, chlorinated
solvents, or methanol-based fluids when wiping down the Meter.